Subaru IMPREZA GD 2007 Series Manual page 2809

asieps_tobira_IM_US.book 36 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CONTROL SYSTEMS
11) Install the plate assembly to the vehicle body.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
12) Install the boot and insulator assembly to the
vehicle body in the proper direction.
13) Install the clamp.
14) Install the console box. <Ref. to EI-46, INSTAL-
LATION, Console Box.>
2. 6MT
1) Insert the gear shift lever from the room side.
NOTE:
After inserting the rod and stay, temporarily posi-
tion them on the transmission mount.
2) Mount the cushion rubber on the vehicle body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
MT Gear Shift Lever
3) Move the transmission to the right side of the ve-
hicle, then attach the joint COMPL and stay.
Tightening torque:
T1:11.8 N·m (1.2 kgf-m, 8.7 ft-lb)
T2:32 N·m (3.3 kgf-m, 23.6 ft-lb)
CS-00157
(A) Reverse check cable
4) Install the crossmember. <Ref. to 6MT-32, IN-
STALLATION, Transmission Mounting System.>
5) Attach the reverse check cable end, washer and
snap pin to the reverse check lever.
NOTE:
• Make sure to attach the snap pin in proper direc-
tion.
• Before installation, perform adjustment of the re-
CS-00100
verse check cable. <Ref. to CS-48, ADJUST-
MENT, Reverse Check Cable.>
(A) Reverse check cable
(B) Washer
(C) Snap pin
(D) Front side
6) Install the rear exhaust pipe and muffler. <Ref. to
EX(H4DOTC)-15, INSTALLATION, Rear Exhaust
Pipe.>, <Ref. to EX(H4DOTC)-17, INSTALLA-
TION, Muffler.>
7) Install the under cover.
CS-00222
CS-36
(A)
T1
T2
(C)
(D)
(A)
(B)
CS-00223
CS-00224