Subaru IMPREZA GD 2007 Series Manual page 2933

asieps_tobira_IM_US.book 28 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
2. Transmission Gear Oil
A: INSPECTION
1) Park the vehicle on a level surface.
2) Turn the ignition switch to OFF, and wait until the
engine cools.
3) Remove the oil level gauge and wipe it clean.
4) Reinsert the level gauge all the way. Be sure that
the level gauge is correctly inserted in the proper
direction.
5) Pull out the oil level gauge again, and record the
oil level. If it is the lower level or below, add oil
through the oil level gauge hole to bring the level up
to the upper level.
(A) Oil level gauge
(B) Upper level
(C) Lower level
Transmission Gear Oil
B: REPLACEMENT
1) Pull out the oil level gauge.
2) Lift up the vehicle.
3) Remove the transmission under cover.
4) Drain transmission gear oil completely.
CAUTION:
Immediately after the vehicle has been running
or after idling for a long time, the ATF will be
hot. Be careful not to receive burns.
NOTE:
• Tighten the drain plug of the transmission gear
oil after draining the transmission gear oil.
• Use a new gasket.
• For removing and installing the drain plug on the
(A) clutch housing side, use TORX
Tightening torque:
(A)
Oil pan side
44 N·m (4.5 kgf-m, 32.5 ft-lb)
Clutch housing side
(B)
70 N·m (7.1 kgf-m, 51.6 ft-lb)
(C)
MT-00449
5) Lower the vehicle.
6) Pour the gear oil into the gauge hole.
RECOMMENDED GEAR OIL
Use GL-5 or equivalent.
Gear oil capacity:
4.1
7) Check the level of the transmission gear oil.
NOTE:
• When inserting the level gauge into the transmis-
sion gear, align the protrusion on the top of the level
gauge with the notch in the gauge hole.
• The gear oil level should be within the specified
range marked on the level gauge.
6MT-28
®
bit T70.
(A)
(A) Drain plug (oil pan side)
(B) Drain plug (clutch housing side)
(4.3 US qt, 3.6 Imp qt)
2
(B)
MT-01549