Subaru IMPREZA GD 2007 Series Manual page 2763

asieps_tobira_IM_US.book 30 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CLUTCH SYSTEM
10.Clutch Pedal
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the steering column. <Ref. to PS-21,
REMOVAL, Tilt Steering Column.>
3) Disconnect the connector from the stop light
switch and clutch switch.
4) Remove the snap pins from clevis pins which se-
cure the lever to the push rod and operating rod.
5) Pull out the clevis pins which secures the lever to
the push rod and operating rod.
(A)
(D)
(C)
(A) Operating rod
(B) Push rod
(C) Snap pin
(D) Clevis pin
6) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H4SO)-6, REMOVAL, Air Intake
Chamber.>
7) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, REMOVAL, Intercool-
er.>
8) Remove the nut which secures the clutch master
cylinder.
9) Remove the bolts and nuts which secure the
brake pedal and clutch pedal, and remove the ped-
al assembly.
Clutch Pedal
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Always use a new clevis pin.
2) Adjust the clutch pedal after installation. <Ref. to
CL-31, ADJUSTMENT, Clutch Pedal.>
3) Adjust the clutch switch (starter interlock). <Ref.
to CL-35, ADJUSTMENT, Clutch Switch.>
C: DISASSEMBLY
1) Remove the clip, assist spring, rod and bushing.
(D)
(C)
(B)
CL-00090
2) Remove the spring pin and lever.
CL-00093
CL-30
(D)
(A)
(E)
(C)
(D)
(D)
(B)
(E)
(C)
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
(A)
(A) Pin
(B) Lever
CL-00354
(B)
CL-00095