Subaru IMPREZA GD 2007 Series Manual page 3435

asieps_tobira_IM_US.book 29 ページ ２０１２年１月１７日 火曜日 午後３時４８分
11) Remove the snap ring using snap ring pliers.
CAUTION:
Be careful not to scratch the pinion and valve
assembly.
12) Press out the bearing together with the back up
washer using pipe with a diameter of 38.5 — 39.5
mm (1.516 — 1.555 in) and press.
(1) Bearing
(2) Back-up washer
(3) Oil seal
(4) Pipe
13) Remove the oil seal.
Steering Gearbox
POWER ASSISTED SYSTEM (POWER STEERING)
2. TURBO MODEL
1) Disconnect the pipes from the steering body and
the control valve housing.
2) Secure the gearbox removed from the vehicle
using C clamp.
PS-00154
(1) C clamp
3) Remove the tie-rod end and lock nut from gear-
box.
4) Remove the clip on outside of boot using pliers,
and then slide the boot to tie-rod end side.
(1)
(2)
(3)
(4)
(1) Clip
5) Using a flat tip screwdriver, remove the band
from boot.
NOTE:
Replace the boot if there is damage, cracks or de-
PS-00157
terioration.
(1) Band
PS-29
(1)
PS-00775
(1)
PS-00661
(1)
PS-00777