Subaru IMPREZA GD 2007 Series Manual page 3345

asieps_tobira_IM_US.book 21 ページ ２０１２年１月１７日 火曜日 午後３時４８分
3) Remove disc cover from housing.
4) Remove the outer and inner oil seals using a flat
tip screwdriver.
5) Remove the snap ring using a flat tip screwdriv-
er.
NOTE:
Be careful not to damage housing during removal.
6) Using ST1, securely support the housing.
7) Using ST2, press the inner race, and push out
the outer race of the bearing.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING PULLER
Front Axle
8) Using the ST and a hydraulic press, push out the
hub bolts.
ST 927080000
DS-00051
2. STI MODEL
1) Remove the four bolts from the housing, and re-
move the front hub unit bearing.
DS-00052
2) Disassemble the front hub unit bearing. <Ref. to
DS-20, DISASSEMBLY, Front Axle.>
D: ASSEMBLY
1. EXCEPT FOR STI MODEL
NOTE:
ST2
When the hub is removed from housing, replace
the bearing set and oil seal with new parts.
1) Attach the hub to the ST securely.
ST 927080000
ST1
DS-00053
DS-21
DRIVE SHAFT SYSTEM
HUB STAND
ST
(A) Housing
HUB STAND
ST
DS-00054
(A)
DS-00371
DS-00055