Suspension - Subaru IMPREZA GD 2007 Series Manual

asieps_tobira_IM_US.book 51 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Brake Pipe
BRAKE
13.Brake Pipe
A: REMOVAL
NOTE:
The airbag system wiring harness is routed near
the center brake pipe.
CAUTION:
• Airbag system connectors are yellow. Do not
use the electrical test equipment on these cir-
cuits.
• Be careful not to damage the airbag system
wiring harness when servicing the center brake
pipe.
• When removing brake pipes, use a flare nut
wrench.
• When removing brake pipes, do not bend.
B: INSTALLATION
NOTE:
The airbag system wiring harness is routed near
the center brake pipe.
CAUTION:
• Airbag system connectors are yellow. Do not
use the electrical test equipment on these cir-
cuits.
• Be careful not to damage the airbag system
wiring harness when servicing the center brake
pipe.
• When removing brake pipes, use a flare nut
wrench.
• When installing the brake pipe, do not bend.
• After installing the brake pipe and hose, per-
form air bleed.
• After installing the brake hoses, make sure
that they do not contact the tires or suspension
assembly, etc.
Tightening torque (brake pipe):
15 N·m (1.5 kgf-m, 10.8 ft-lb)
C: INSPECTION
Check that there are no cracks, breakage, or dam-
age on hoses. Check the joints for fluid leakage. If
any cracks, breakage, damage or leakage is found,
repair or replace the pipe.
NOTE:
Check the part, which is difficult to see such as the
backside using a mirror.
BR-51