Subaru IMPREZA GD 2007 Series Manual page 3239

asieps_tobira_IM_US.book 30 ページ ２０１２年１月１７日 火曜日 午後３時４８分
BRAKE
3. 17-INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift up the vehicle, then remove the rear wheels.
4) Remove the clip.
(1) Clip
5) Remove the pad pin and cross spring.
(2)
(1) Cross spring
(2) Pad pin
6) Spread the pads apart and push back the piston.
7) Remove the pad.
(1) Brake pad
Rear Brake Pad
(1)
BR-00313
(1)
BR-00311
(1)
BR-00312
BR-30
B: INSTALLATION
1. 14-INCH TYPE
1) Apply a thin coat of Molykote M7439 (Part No.
003602001) to the contact surface between the
pad and pad clip.
2) Apply a thin coat of Molykote AS-880N (Part No.
K0777YA010) to the contact surface between the
pad and shim.
3) Install the pad to support.
4) Install the caliper body to the support.
Tightening torque:
37 N·m (3.8 kgf-m, 27.5 ft-lb)
NOTE:
If it is difficult to push the piston during pad replace-
ment, loosen the air bleeder screws to facilitate
work.
2. 15-INCH TYPE
1) Apply a thin coat of Molykote AS-880N (Part No.
K0777YA010) to both surfaces of the pad inner
shim, and Molykote M7439 (Part No. 003602001)
to the sides of pad.
BR-00599
BR-00602
BR-00605