Subaru IMPREZA GD 2007 Series Manual page 2817

asieps_tobira_IM_US.book 44 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CONTROL SYSTEMS
NOTE:
• Install the lock wire to the stay groove.
• Bend the extra wire to the same direction of lock
wire winding.
(A)
B
(B)
B - B
(A) Inner boot
(B) Lock wire
(C) Stay
11) Insert the reverse check cable into the boot
hole.
12) Insert the reverse check cable into the gear
shift assembly, and fix in place with a band clip.
NOTE:
• Cut the excess band clip.
• Make sure that the reverse check cable is insert-
ed into the gearshift lever with no gaps.
MT Gear Shift Lever
13) Attach the seat cushion and spring.
(A)
B
(B)
(C)
14) Use a spring pin to hold the slider and end of
the reverse check cable in place.
NOTE:
Apply grease to the moving part of slider.
(B)
CS-00240
15) While pulling the cable (the slider is lowered),
adjust the length between the cable plate end and
the reverse check cable to 84 mm (3.31 in), and
tighten the locknut.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
CS-00227
CS-44
(A)
(B)
(A) Spring
(B) Seat cushion
(B)
(A)
(A) Slider
(B) Spring pin
(A)
(A) 84 mm (3.31 in)
CS-00763
CS-00761
CS-00242