Subaru IMPREZA GD 2007 Series Manual page 3251

asieps_tobira_IM_US.book 42 ページ ２０１２年１月１７日 火曜日 午後３時４８分
BRAKE
B: INSTALLATION
1) Check and adjust the operating rod of the brake
booster.
Specification L:
144.6 mm (5.69 in)
If it is out of specification, adjust it with the brake
booster operating rod.
2) Mount the brake booster in position.
3) Connect the operating rod to brake pedal with
clevis pin and snap pin.
(2)
(4)
(1) Nut
(2) Clevis pin
(3) Snap pin
(4) Operating rod
Brake Booster
4) Connect the vacuum hose to brake booster.
L
5) Mount the master cylinder onto the brake boost-
er.
6) Connect the brake pipes to the master cylinder.
7) Connect the connector of the brake fluid level
gauge.
8) Measure the clearance between the threaded
BR-00076
end of the stop light switch and the stopper.
If it is not within the specification, adjust it by adjust-
ing the position of the stop light switch. <Ref. to BR-
56, ADJUSTMENT, Stop Light Switch.>
CAUTION:
Be careful not to rotate the stop light switch.
Stop light switch clearance A:
(1)
(3)
9) Apply grease to the operating rod connecting pin
to prevent it from wear.
10) Bleed air from brake system.
Tightening torque (air bleeder screw):
BR-00073
11) Perform a road test to make sure the brakes do
not drag.
BR-42
0.3 mm (0.012 in)
Excluding the 17-inch type:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
17-inch type:
20 N·m (2.0 kgf-m, 14.5 ft-lb)
BR-00078
A
BR-00079