Subaru IMPREZA GD 2007 Series Manual page 2821

asieps_tobira_IM_US.book 48 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CONTROL SYSTEMS
5) Attach the reverse check cable, washer and
snap pin to the reverse check lever.
NOTE:
Make sure to attach the snap pin in proper direc-
tion.
(D)
(B)
(A) Reverse check cable
(B) Washer
(C) Snap pin
(D) Front side
6) Fix the reverse check cable to the stay clip.
NOTE:
Attach the reverse check cable on top of the stay.
(A)
(A) Reverse check cable
(B) Clip
7) Install the rear exhaust pipe and muffler. <Ref. to
EX(H4DOTC)-15, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4DOTC)-17, INSTALLATION,
Muffler.>
8) Install the console box. <Ref. to EI-46, INSTAL-
LATION, Console Box.>
Reverse Check Cable
(C)
(A)
CS-00224
(B)
CS-00243
CS-48
C: INSPECTION
1) Make sure the slider moves smoothly. If it does
not move, adjust the reverse check cable, or check
the slider for damage. <Ref. to CS-48, ADJUST-
MENT, Reverse Check Cable.>
2) Check that the gear shifts into reverse position
when the slider is pulled up. If the gear does not
shift into reverse, adjust the reverse check cable.
<Ref. to CS-48, ADJUSTMENT, Reverse Check
Cable.>
3) Check that the gear is not shifted to the reverse
when the slider is not lifted. If the gear shifts into re-
verse, adjust or replace the reverse check cable.
<Ref. to CS-48, ADJUSTMENT, Reverse Check
Cable.>
D: ADJUSTMENT
1) Set the vehicle on a lift.
2) Remove the under cover.
3) Remove the rear exhaust pipe and muffler.
<Ref. to EX(H4DOTC)-15, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-17, REMOV-
AL, Muffler.>
4) Remove the crossmember. <Ref. to 6MT-32,
REMOVAL, Transmission Mounting System.>
5) Remove the snap pin and washer, and separate
the reverse check cable from the reverse check le-
ver.
(B)
(A) Snap pin
(B) Washer
(C) Reverse check cable
(A)
(C)
CS-00220