Subaru IMPREZA GD 2007 Series Manual page 3311

asieps_tobira_IM_US.book 45 ページ ２０１２年１月１７日 火曜日 午後３時４８分
22) Press the side bearing into differential case us-
ing ST.
ST 398487700 DRIFT
ST
23) Assemble the side bearing retainer.
(1) Using the ST and a press, press in the side
bearing outer race.
ST 398417700 DRIFT
ST
(2) Install the oil seal. <Ref. to DI-53, RE-
PLACEMENT, Rear Differential Side Oil Seal.>
24) Adjusting the side bearing retainer shims
(1) The driven gear backlash and side bearing
preload can be adjusted by the side bearing re-
tainer shim thickness.
(2) Install the differential case assembly into dif-
ferential carrier in the reverse order of disas-
sembly.
NOTE:
Be careful so that the teeth do not hit against the
case.
Rear Differential
(3) Install the side bearing retainer shims to RH
and LH retainers from the position where they
were removed.
NOTE:
Replace broken or corroded side bearing retainer
shims with a new part of the same thickness.
Part No.
383475201
383475202
383475203
383475204
DI-00095
383475205
(4) Align the arrow mark on differential carrier
with the mark on side bearing retainer during in-
stallation.
NOTE:
Be careful that side bearing outer race is not dam-
aged by the bearing roller.
DI-00324
(A) Arrow mark
(5) Tighten the side bearing retainer bolts.
Tightening torque:
10.5 N·m (1.1 kgf-m, 7.7 ft-lb)
DI-00065
DI-45
DIFFERENTIALS
Side bearing retainer shim
Thickness mm (in)
0.20 (0.0079)
0.25 (0.0098)
0.30 (0.0118)
0.40 (0.0157)
0.50 (0.0197)
(A)
DI-00097
DI-00098