Subaru IMPREZA GD 2007 Series Manual page 3362

asieps_tobira_IM_US.book 38 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DRIVE SHAFT SYSTEM
17) Install the snap ring in the groove on the DOJ
outer race.
NOTE:
• Assure that the balls, cage and inner race are
completely fitted in the outer race of DOJ.
• Use care not to place the matched position of
snap ring in the ball groove of outer race.
• Pull the shaft lightly and assure that the circlip is
completely fitted in the groove.
18) Apply an even coat of the specified grease [20
to 30 g (0.71 to 1.06 oz)] to the entire inner surface
of boot. Also apply grease to the shaft.
19) Install the DOJ boot taking care not to twist it.
NOTE:
• The inside of the larger end of DOJ boot and the
boot groove shall be cleaned so as to be free from
grease and other substances.
• When installing the DOJ boot, position the outer
race of DOJ at center of the stroke.
20) Extend and retract the DOJ to provide equal
grease coating.
21) Put a new band through the clip and wind twice
in the band groove of the boot.
NOTE:
When tightening boot, use care so that the air with-
in the boot is appropriate.
22) Tighten the band using the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE:
Tighten the band until it cannot be moved by hand.
Front Drive Shaft
23) Tap the clip with the punch provided at the end
of the ST.
ST 925091000
NOTE:
Tap to an extent that the boot underneath is not
damaged.
24) Cut off the band with an allowance of about 10
mm (0.39 in) left from the clip and bend this allow-
DS-00125
ance over the clip.
NOTE:
Be careful so that the end of the band is in close
contact with clip.
E: INSPECTION
Check the removed parts for damage, wear, corro-
sion etc. If faulty, repair or replace.
1) DOJ (Double Offset Joint)
Check for seizure, corrosion, damage, wear and
excessive play.
2) PTJ (Pillow Tripod Joint)
Check for seizure, corrosion, damage and exces-
sive play.
3) Shaft
Check for excessive bending, twisting, damage
and wear.
4) BJ (Ball Fixed Joint)
Check for seizure, corrosion, damage and exces-
sive play.
5) Boot
Check for wear, warping, breakage and scratches.
6) Grease
Check for discoloration and fluidity.
DS-00132
DS-38
BAND TIGHTENING TOOL
DS-00133