Subaru IMPREZA GD 2007 Series Manual page 3461

asieps_tobira_IM_US.book 55 ページ ２０１２年１月１７日 火曜日 午後３時４８分
13) Finally, check clearance between pipes or hoses as shown in the figure.
If the cruise control actuator and power steering hose clearance is less than 10 mm (0.39 in), move section
(A) held in place by the clamp, or bend (B) to adjust.
(1) High-pressure hose
C: INSPECTION
Check all disassembled parts for wear, damage or other problems. Repair or replace the defective parts as
necessary.
Part
Pipe
Clamp
Hose
Pipe Assembly
(B)
(A)
(2) No interference is allowed
between hoses.
Inspection
• O-ring fitting surface damage
• Nut damage
• Pipe damage
• Loose clamps
• Flare surface damage
• Flare nut damage
• Outer surface cracks
• Outer surface wear
• Clip damage
• End coupling or adapter deformation
PS-55
POWER ASSISTED SYSTEM (POWER STEERING)
(1)
(2)
(3)
(3) Crossmember to pipe clearance:
3 — 8 mm (0.12 — 0.31 in)
Corrective action
Replace with a new part.
Replace with a new part.
Replace with a new part.
PS-00179