Subaru IMPREZA GD 2007 Series Manual page 2747

asieps_tobira_IM_US.book 14 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CLUTCH SYSTEM
2. Clutch Disc and Cover
A: REMOVAL
1) Remove the transmission assembly from vehicle
body.
5MT:
<Ref. to 5MT-25, REMOVAL, Manual Transmis-
sion Assembly.>
6MT:
<Ref. to 6MT-34, REMOVAL, Manual Transmis-
sion Assembly.>
2) Attach the ST on the flywheel.
ST 499747100 CLUTCH DISC GUIDE
( A )
(A) Clutch cover
3) Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil to touch the clutch disc
face.
• Do not disassemble the clutch cover or clutch
disc.
B: INSTALLATION
1) Insert the ST into the clutch disc and attach to
the flywheel by inserting the ST end into pilot bear-
ing.
NOTE:
When installing the clutch disc, be careful to attach
in the correct direction.
ST 499747100 CLUTCH DISC GUIDE
(A) Flywheel side
Clutch Disc and Cover
2) Install the clutch cover to the flywheel and tight-
en the bolts to the specified torque.
NOTE:
• When installing the clutch cover to the flywheel,
position the clutch cover so that the distance be-
tween unbalance marks (
120°. (The unbalance marks
tions of residual unbalance.)
• Note the front and rear of the clutch disc when in-
stalling.
• Temporarily tighten the bolts by hand. Each bolt
should be tightened to the specified torque in a
crisscross order.
Tightening torque:
S T
CL-00011
3) Remove the ST.
ST 499747100
4) Install the transmission assembly.
5MT:
<Ref. to 5MT-28, INSTALLATION, Manual Trans-
mission Assembly.>
6MT:
(A)
<Ref. to 6MT-36, INSTALLATION, Manual Trans-
ST
mission Assembly.>
CL-00208
CL-14
paint marks) is at least
16 N·m (1.6 kgf-m, 11.8 ft-lb)
( A )
( 3 )
( 1 )
( 5 )
( 2 )
( 4 )
(A) Unbalance mark (paint)
CLUTCH DISC GUIDE
indicate the direc-
( 6 )
S T
CL-00013