Subaru IMPREZA GD 2007 Series Manual page 2628

asieps_tobira_IM_US.book 121 ページ ２０１２年１月１７日 火曜日 午後３時４８分
3) Install the reverse clutch to the high clutch drum.
Align the groove on reverse clutch piston with the
groove on high clutch drum during installation.
(A)
(A) Reverse clutch piston
(B) High clutch drum
4) Install the spring retainer to the high clutch pis-
ton.
(A)
(A) Return spring
(B) High clutch drum
5) Attach the ST to the high clutch piston.
ST 498437000 HIGH CLUTCH PISTON
GUIDE
6) Install the cover to the high clutch piston while
making sure not to bend the high clutch piston seal.
AT Main Case
7) Using the ST1, ST2 and ST3, install the snap
ring.
ST1 398673600
ST2 498627100
ST3 498437000
(B)
AT-00241
8) Install the thickest driven plate to piston side,
and then install the driven plate, drive plate, retain-
ing plate to high clutch drum.
(B)
AT-00242
9) Install the snap ring to high clutch drum.
10) Apply compressed air intermittently to check for
operation.
ST
11) High clutch retaining plate selection (non-turbo
model)
AT-00243
(1) Place the dish plate, driven plate, drive plate
and retaining plate neatly in this order on sur-
face table.
(2) Set the dial gauge to clutch, and read its
scale.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
4AT-121
AUTOMATIC TRANSMISSION
COMPRESSOR
SEAT
HIGH CLUTCH PISTON
GUIDE
ST1
ST3
ST2
AT-00244
AT-00245
AT-00246