Subaru IMPREZA GD 2007 Series Manual page 3293

asieps_tobira_IM_US.book 27 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5) Keep the side bearing retainers separate to
make it possible to identify RH and LH sides. Re-
move the side bearing retainer attaching bolts, set
the ST to differential case, and extract the side
bearing retainers RH and LH with a puller.
NOTE:
Each shim, which is installed to adjusted the side
bearing preload, should be kept together with its
mating retainer.
ST 398457700 ATTACHMENT
ST
6) Pull out the differential case assembly from dif-
ferential carrier.
NOTE:
Be careful so that the teeth do not hit against the
case.
7) When replacing the side bearing, remove the
bearing cup from the side bearing retainer using
ST.
ST 398527700 PULLER ASSY
Rear Differential
8) Remove the bearing cone with ST.
NOTE:
• Do not attempt to disassemble the parts unless
necessary.
• Set the puller so that its claws catch the edge of
the bearing cone.
• Never mix up the RH and LH bearing races and
cones.
ST 18759AA000 PULLER ASSY
DI-00064
9) Remove the hypoid driven gear by loosening hy-
poid driven gear bolts.
10) Drive out the pinion shaft lock pin from hypoid
driven gear side. (Model without LSD)
NOTE:
DI-00065
The lock pin is staked at the pin hole end on the dif-
ferential carrier. Do not drive it out forcibly before
removing the stake.
ST 899904100
ST
DI-00066
DI-27
DIFFERENTIALS
ST
DI-00316
DI-00068
STRAIGHT PIN REMOVER
ST
DI-00237