Subaru IMPREZA GD 2007 Series Manual page 3385

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
D: ASSEMBLY
1. FRONT BUSHING
Assemble in the reverse order of disassembly.
CAUTION:
Install the front bushing in proper direction as
shown in the figure.
(3)
(1)
(2)
(1) Face the bushing toward the center of ball joint.
(2) Ball joint
(3) ±3°
2. REAR BUSHING
1) Attach the rear bushing to the transverse link
and align the two aligning marks.
2) Attach and tighten a new self-locking nut.
NOTE:
While holding the rear bushing so as not to change
position of aligning marks, tighten the self-locking
nut.
Tightening torque:
190 N·m (19.4 kgf-m, 140 ft-lb)
E: INSPECTION
1) Check the transverse link for wear, damage and
cracks, and correct or replace if defective.
2) Check the bushing for major cracks, fatigue or
damage.
3) Check the rear bushing for oil leaks.
Front Transverse Link
FS-00102
FS-15
FRONT SUSPENSION