Subaru IMPREZA GD 2007 Series Manual page 2947

asieps_tobira_IM_US.book 42 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
11.Back-up Light Switch
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 6MT-34, REMOVAL,
Manual Transmission Assembly.>
2) Disconnect the back-up light switch connector.
(A)
(C)
(B)
(A) Back-up light switch connector (White)
(B) Neutral position switch connector (Black)
(C) Clip
3) Disconnect the back-up light switch.
(A) Back-up light switch
(B) Neutral position switch
B: INSTALLATION
1) Install the back-up light switch.
Tightening torque:
32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A) Back-up light switch
(B) Neutral position switch
Back-up Light Switch
(C)
MT-00471
(A)
(B)
MT-00472
(A)
(B)
MT-00472
6MT-42
2) Connect the back-up light switch connector.
(A)
(C)
(C)
(B)
(A) Back-up light switch connector (White)
(B) Neutral position switch connector (Black)
(C) Clip
3) Install the manual transmission assembly to the
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: INSPECTION
1) Disconnect the ground cable from battery.
2) Remove the intercooler. <Ref. to IN(H4DOTC)-
13, REMOVAL, Intercooler.>
3) Disconnect the transmission harness and chas-
sis harness.
(A) Transmission connector
4) Measure the resistance between the back-up
light switch terminals. If it is not within the specifica-
tion, replace the back-up light switch.
Gear shift position Terminal No.
Back position
3 and 6
Other positions
MT-00471
(A)
MT-00473
Specification
Less than 1 Ω
1 MΩ or more
3 2 1
6 5 4
MT-00946