Subaru IMPREZA GD 2007 Series Manual page 2618

asieps_tobira_IM_US.book 111 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: INSTALLATION
1) Install the low & reverse piston.
NOTE:
Take care not to damage the lip seal.
2) Install the return spring.
3) Install the spring retainer.
4) Install the one-way clutch inner race, spring re-
tainer and return spring.
5) Tighten the socket head bolts evenly from the
rear side of transmission case.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
AT Main Case
6) Place the front side of transmission body up.
7) Install the thrust needle bearing.
8) Place the dish plate, driven plate, drive plate and
retaining plate neatly in this order on surface table.
9) Set the micro gauge to retaining plate, and read
its scale. Measure at three locations or more
spaced by equal distances and take the average
value.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
10) Scale and record the weight "Z" of a flat board
which will be put on retaining plate.
NOTE:
AT-00300
• Use a stiff board which does not bend against
load as a flat board to be put on retaining plate.
• Use a flat board weighing less than 8.5 kg (18.7
lb).
11) Put the flat board on retaining plate.
AT-00301
12) Using the following formula, read the push/pull
gauge, and calculate "N".
N = 83 N (8.5 kgf, 18.7 lbf) – Z
N: Value indicated on push/pull gauge
83 N (8.5 kgf, 18.7 lbf): Load applied to clutch plate
Z: Flat board weight
AT-00302
AT-00296
4AT-111
AUTOMATIC TRANSMISSION
AT-01720