Subaru IMPREZA GD 2007 Series Manual page 3358

asieps_tobira_IM_US.book 34 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DRIVE SHAFT SYSTEM
7) Wipe off the grease and take out the ball bear-
ings.
NOTE:
• The grease is a special grease (grease for con-
stant velocity joints). Do not mix with other greases.
• Disassemble exercising care not to lose balls (6
pcs).
(A) Outer race
(B) Grease
8) To remove the cage from inner race, turn the
cage by a half pitch to the track groove of inner race
and shift the cage.
9) Using pliers, remove the snap ring fixing the in-
ner race to the shaft.
10) Take out the DOJ inner race.
11) Take off the DOJ cage from shaft and remove
the DOJ boot.
12) Wrap vinyl tape around the spline part of shaft.
13) Remove the BJ boot using the same proce-
dures as for the DOJ boot.
NOTE:
The BJ is a non-disassembly part, so the axle dis-
assembly stops here.
D: ASSEMBLY
1. BJ+PTJ-TYPE
NOTE:
Use specified grease.
BJ side:
NTG2218-M (Part No. 28395AG030)
PTJ side:
NKG302 (Part No. 28495AE010)
1) Set BJ boot and small boot band on the BJ side
of shaft.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
protect the boot from scratches.
2) Set the drive shaft on a vise.
CAUTION:
Do not set the drive shaft on a vise directly. Be
sure to use wooden blocks.
Front Drive Shaft
(A)
(B)
DS-00126
DS-34
3) Apply a thin coat of specified grease [60 to 70 g
(2.12 to 2.47 oz)] to the BJ.
4) Apply an even coat of the specified grease [20 to
30 g (0.71 to 1.06 oz)] to the entire inner surface of
boot. Also apply grease to the shaft.
NOTE:
The BJ installing surface of BJ boot shall be
cleaned completely so as to be free from grease
and other substances.
5) Attach the boot protrusion on the BJ groove.
(B)
(A)
(A) BJ
(B) Large boot band
(C) Boot
6) Set the large boot band in the specified position.
7) Attach the boot protrusion on the shaft groove.
(A)
(A) Boot
(B) Small boot band
(C) Shaft
(C)
DS-00114
(B)
(C)
DS-00115