Subaru IMPREZA GD 2007 Series Manual page 2954

asieps_tobira_IM_US.book 49 ページ ２０１２年１月１７日 火曜日 午後３時４８分
18) Install the selector arm No. 2, shifter arm, se-
lector plunger and spring. (Transmission serial No.
144577 or later)
(A)
(C)
(A) Selector arm No. 2
(B) Shifter arm
(C) Selector plunger
19) Install a new spring pin.
20) Using the ST, install the neutral set spring and
support.
ST1 18756AA000 CLAW
ST2 399893600 PLIER
ST2 ST2
21) Install the flat washer and snap ring.
22) Install the center differential.
Extension Case
2. TRANSFER DRIVE GEAR THRUST
WASHER SELECTION
1) Measure height "Z" between the transmission
case end area and ST.
ST 499575500
(B)
2) Measure depth "Y" between the end of the ST
and the transfer drive gear.
ST 499575500
MT-02713
3) Using the following calculation, calculate the
transfer drive gear thrust washer value t.
ST1
t = {Y – 15 mm (1.18 in)} – {Z – 15 mm (1.18 in)} –
0.75 — 0.95 mm (0.030 — 0.037 in)
MT-01092
(0.030 — 0.037 in)
6MT-49
MANUAL TRANSMISSION AND DIFFERENTIAL
GAUGE
ST
GAUGE
ST
ST
t Transfer drive gear thrust washer
mm (in) thickness
Y Depth between the end of the ST
mm (in) and the transfer drive gear
Z Height from the end of the transmis-
mm (in) sion case to the end of the ST.
Standard clearance between the
0.75 — 0.95 mm
thrust washer and transfer drive
gear
15 mm (1.18 in) Thickness of ST
Z
MT-00949
Y
MT-01421