Subaru IMPREZA GD 2007 Series Manual page 2560

asieps_tobira_IM_US.book 53 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4) Apply an adequate amount of liquid gasket to the
three holes excluding the screw holes of the trans-
mission case.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
or equivalent
5) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
6) Connect the connector of the rear vehicle speed
sensor. (MP-T model)
(A) Rear vehicle speed sensor
7) Connect the connector of the rear vehicle speed
sensor. (VTD model)
(A) Rear vehicle speed sensor
Front Vehicle Speed Sensor
AT-02123
(A)
AT-02207
(A)
AT-03601
4AT-53
AUTOMATIC TRANSMISSION
8) Install the front vehicle speed sensor and torque
converter turbine speed sensor, and then fasten
the harness.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
( B )
(A) Front vehicle speed sensor
(B) Torque converter turbine speed sensor
9) Install the inlet pipe.
NOTE:
Use a new copper washer.
Tightening torque:
T1: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
T2: 40 N·m (4.1 kgf-m, 29.5 ft-lb)
T3: 45 N·m (4.6 kgf-m, 33 ft-lb)
T1
10) Install the transmission rear crossmember bolt.
Tightening torque:
70 N·m (7.1 kgf-m, 51 ft-lb)
11) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
12) Install the front, center and rear exhaust pipes,
and the muffler. (Non-turbo model) <Ref. to
EX(H4SO)-5, INSTALLATION, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-8, INSTALLATION,
Rear Exhaust Pipe.> <Ref. to EX(H4SO)-9, IN-
STALLATION, Muffler.>
13) Install the center, rear exhaust pipes and the
muffler. (Turbo model) <Ref. to EX(H4DOTC)-11,
INSTALLATION, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-15, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4DOTC)-17, INSTALLATION,
Muffler.>
( A )
AT-00044
T2
T3
AT-03826