Subaru IMPREZA GD 2007 Series Manual page 3000

asieps_tobira_IM_US.book 95 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5) Attach ST3 to the locknut, and set the drive pin-
ion shaft to the ST. Remove the lock nut and wash-
er.
ST1 18667AA000 HOLDER
ST2 18664AA000 BASE
ST3 18621AA000 ADAPTER WRENCH
ST3
ST1
6) Using the ST, remove the taper roller bearing as-
sembly.
ST 18723AA000 REMOVER
D: ASSEMBLY
1) Using the ST, measure drive pinion measure-
ment "A".
NOTE:
When selecting the drive pinion shim, refer to mea-
surement "A".
ST 398643600 GAUGE
Drive Pinion Shaft Assembly
ST2
MT-00643
ST
MT-00644
ST
A MT-00645
6MT-95
MANUAL TRANSMISSION AND DIFFERENTIAL
2) Using the ST and a press, attach the inner bear-
ing inner race to the drive pinion shaft.
ST 18723AA000 REMOVER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 Imp ton).
3) Using the ST and a press, attach the retainer
and outer bearing inner race to the drive pinion
shaft.
ST 18723AA000 REMOVER
NOTE:
Push in to a position where the bearing rotates
smoothly.
(A)
(A) Retainer
4) Attach the washer and a new lock nut.
ST
MT-00646
ST
MT-00647