Subaru IMPREZA GD 2007 Series Manual page 3356

asieps_tobira_IM_US.book 32 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DRIVE SHAFT SYSTEM
6) Connect the transverse link to the housing.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
7) Install the stabilizer bracket.
8) While pressing the brake pedal, tighten the axle
nut to the specified torque.
Tightening torque:
220 N·m (22.4 kgf-m, 162 ft-lb)
CAUTION:
• Be sure to tighten the axle nut before install-
ing the wheel to the vehicle. If the wheel is in-
stalled while the axle nut is loose, the wheel
bearings may be damaged when the tires con-
tact the ground.
• Do not overtighten it as this may damage the
wheel bearing.
9) After tightening axle nut, lock it securely.
C: DISASSEMBLY
1. BJ+PTJ-TYPE
1) Place alignment marks on the shaft and outer
race.
2) Remove the PTJ boot band and boot.
CAUTION:
Be careful not to damage the boot.
Front Drive Shaft
3) Remove the snap ring from the PTJ outer race
using a screwdriver.
4) Remove the PTJ outer race from shaft assembly.
5) Wipe off grease.
CAUTION:
The grease is a special type of grease. Do not
mix with other grease.
6) Place alignment marks on the roller kit and trunnion.
DS-00106
7) Remove the roller kit from trunnion.
CAUTION:
Be careful with the roller kit position.
8) Place alignment marks on the trunnion and shaft.
DS-00107
DS-32
DS-00108
DS-00208
DS-00110