Subaru IMPREZA GD 2007 Series Manual page 2979

asieps_tobira_IM_US.book 74 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
(3) Using the ST, push in to the 3rd-4th hub and
4th bushing all at once.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 Imp ton).
NOTE:
When pushing into the 3rd-4th hub and 4th bush-
ing, move the outer baulk ring to match the protru-
sion of the outer baulk ring and the cut out on the
3rd-4th bushing.
(E)
(E)
(A)
(B)
(A) 3rd-4th hub
(B) Outer baulk ring
(C) Cut out on the 3rd-4th hub
(D) Protrusion of the outer baulk ring
(E) 4th bushing
5) Make sure that the 3rd drive gear can be turned
smoothly by hand. If it does not turn smoothly, re-
assemble.
Main Shaft Assembly
6) Attach the 3rd-4th shifting insert key at the ap-
propriate position of the 3rd-4th sleeve.
NOTE:
The angle of each shifting insert key is 120°.
ST1
(A)
ST2
(C)
(D)
7) Attach the 3rd-4th sleeve to the 3rd-4th hub.
NOTE:
• There is an identification groove on the 3rd-4th
sleeve.
MT-00555
• Place the groove towards the 3rd drive gear, and
attach the 3rd-4th sleeve.
6MT-74
(B)
(A) 3rd-4th sleeve
(B) 3rd-4th shifting insert key
(B)
(A) 3rd drive gear
(B) 3rd-4th sleeve identification groove (1 groove)
(A)
MT-00673
(A)
MT-00563