Subaru IMPREZA GD 2007 Series Manual page 2819

asieps_tobira_IM_US.book 46 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CONTROL SYSTEMS
8. Reverse Check Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Remove the gear shift knob.
3) Remove the console box front. <Ref. to EI-46,
REMOVAL, Console Box.>
4) Remove the spring pin from the slider.
(A)
(A) Slider
(B) Spring pin
5) Remove the slider and spring.
(A) Slider
(B) Spring
6) Cut the band clip, and separate the reverse
check cable from the gear shift lever.
7) Lift up the vehicle.
8) Remove the under cover.
9) Remove the rear exhaust pipe and muffler.
<Ref. to EX(H4DOTC)-15, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-17, REMOV-
AL, Muffler.>
Reverse Check Cable
10) Remove the crossmember. <Ref. to 6MT-32,
REMOVAL, Transmission Mounting System.>
11) Remove the snap pin and washer, and sepa-
rate the reverse check cable from the reverse
check lever.
(B)
CS-00761
12) Move the transmission to the right side of the
vehicle, and remove the stay bolts and reverse
check cable.
NOTE:
If the transmission is not moved aside, the stay
(A)
bolts may contact the body and cause damage.
(B)
CS-00762
13) Lift the stay clip, and separate the stay and the
reverse check cable.
CS-00227
CS-46
(A)
(B)
(C)
(A) Snap pin
(B) Washer
(C) Reverse check cable
(A)
(B)
(A) Stay
(B) Stay bolt
(B)
(A)
(A) Reverse check cable
(B) Clip
CS-00220
CS-00245
CS-00243