Subaru IMPREZA GD 2007 Series Manual page 2462

asieps_tobira_IM_US.book 61 ページ ２０１２年１月１７日 火曜日 午後３時４８分
(3) Install the rocker cover on cylinder head.
Ensure the gasket is properly positioned during
installation.
(4) Temporarily tighten the rocker cover tight-
ening bolt in alphabetical sequence shown in
the figure, and then tighten to specified torque
in alphabetical order.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
(C),(K)
(E)
(A),(I)
(G)
(D),(L)
5) Install the oil pipe.
NOTE:
Be careful of the installing location of the union
screw; the location will differ depending on whether
or not there is a filter.
Tightening torque:
29 N·m (3.0 kgf-m, 21.4 ft-lb)
(C)
(A)
(A) Union screw with filter (with protrusion)
(B) Union screw without filter (without protrusion)
(C) Oil pipe
6) Connect the oil flow control solenoid valve con-
nector.
Camshaft
7) Similarly, install the parts on right-hand side.
8) Install the tensioner bracket.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
(H)
(B),(J)
9) Install the timing belt cover No. 2 (RH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
(F)
ME-00777
(B)
10) Install the timing belt cover No. 2 (LH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
ME-02834
11) Install
ME(H4DOTC)-56, INSTALLATION, Cam Sprock-
et.>
12) Install the timing belt. <Ref. to ME(H4DOTC)-
50, INSTALLATION, Timing Belt.>
13) Install
ME(H4DOTC)-47, INSTALLATION, Timing Belt
Cover.>
14) Install the crank pulley. <Ref. to ME(H4DOTC)-
46, INSTALLATION, Crank Pulley.>
15) Install the V-belts. <Ref. to ME(H4DOTC)-44,
INSTALLATION, V-belt.>
ME-00770
ME(H4DOTC)-61
MECHANICAL
ME-00105
ME-00107
ME-00106
the cam sprocket. <Ref.
the timing belt cover.
to
<Ref. to