Subaru IMPREZA GD 2007 Series Manual page 2623

asieps_tobira_IM_US.book 116 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
Initial standard:
1.7 — 2.1 mm (0.067 — 0.083 in)
Limit thickness:
2.3 mm (0.091 in)
Retaining plate
Part No.
31567AA991
31567AB001
31567AB011
31567AB021
31567AB031
31567AB041
NOTE:
If the drive plate is not being replaced, do not ad-
just.
25) Be careful not to mistake the location of the leaf
spring to be installed.
(A)
(B)
(A) Leaf spring
(B) Retaining plate
26) Install the thrust needle bearing in the correct
direction.
(A)
(A) Snap ring
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
AT Main Case
27) Install the front sun gear and the thrust needle
bearing.
Thickness mm (in)
5.6 (0.220)
5.8 (0.228)
6.0 (0.236)
6.2 (0.244)
6.4 (0.252)
6.6 (0.260)
28) Install the high clutch hub.
Attach the thrust needle bearing to hub using Vase-
line, and then install the hub by correctly engaging
the splines of the front planetary carrier.
29) Install the thrust needle bearing in the proper
direction.
AT-00252
(C)
(E)
(D)
(B)
30) Install the high clutch assembly.
AT-02217
4AT-116
(A)
(B)
(A) Front sun gear
(B) Thrust needle bearing
(C) Clutch hub side
(D) Front sun gear side
(E) Outside
(B)
(A) High clutch hub
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
(A)
(A) High clutch and reverse clutch ASSY
(C)
(E)
(D)
AT-02218
(C)
(E)
(D)
(A)
AT-02219
AT-00235