Subaru IMPREZA GD 2007 Series Manual page 2596

asieps_tobira_IM_US.book 89 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5) Install new seal pipe to converter case.
(A) Seal pipe
6) Install the rubber seal to converter case.
(A) Rubber seal
7) Apply proper amount of liquid gasket to the en-
tire matching surface of converter case.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
(A)
(A) THREE BOND 1215
(B) Rubber seal
Converter Case
8) Install the converter case assembly without
damaging bushing and oil seal.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
AT-00176
9) Insert the inhibitor switch and transmission con-
(A)
nector to the stay.
10) Install the air breather hose. <Ref. to 4AT-67,
INSTALLATION, Air Breather Hose.>
11) Install the oil cooler pipe. <Ref. to 4AT-66, IN-
STALLATION, ATF Cooler Pipe and Hose.>
12) Install the oil charge pipe with O-ring. <Ref. to
4AT-68, INSTALLATION, Oil Charge Pipe.>
13) Insert the input shaft, and check the amount of
protrusion.
AT-00178
NOTE:
Turn the input shaft lightly by hand while inserting.
Normal protrusion amount A:
50 — 55 mm (1.97 — 2.17 in)
(B)
14) Install the torque converter clutch assembly.
<Ref. to 4AT-69, INSTALLATION, Torque Convert-
er Clutch Assembly.>
AT-00179
15) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-39, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Measure the backlash, and then adjust it to be with-
in standard values. <Ref. to 4AT-99, ADJUST-
MENT, Drive Pinion Shaft Assembly.>
4AT-89
AUTOMATIC TRANSMISSION
AT-02386
A
AT-02384