Subaru IMPREZA GD 2007 Series Manual page 3240

asieps_tobira_IM_US.book 31 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2) Install the pad to the caliper body.
3) Attach the cross spring.
4) Install the pad pin to the caliper body.
5) Attach the M clip.
3. 17-INCH TYPE
1) Apply a thin coat of Molykote AS-880N (Part No.
K0777YA010) to both surfaces of the pad inner
shim, and Molykote M7439 (Part No. 003602001)
to the sides of pad.
2) Install the pad to the caliper body.
3) Attach the cross spring and pad pin.
4) Install the clip.
C: INSPECTION
1. 14-INCH TYPE
Check the pad thickness A.
A
Standard
Pad thickness
Wear limit
NOTE:
• Always replace the pads of both sides as a set.
• Replace pad clips if they are twisted or worn.
• A wear indicator is installed on the inner disc
brake pad. If the pad is worn to the limit, the end of
wear indicator contacts disc rotor, and a squeaking
sound is heard as the wheel rotates. If the sound is
heard, replace the pad.
• Replace the pad if there is oil or grease on it.
Rear Brake Pad
2. 15-INCH TYPE
Check the pad thickness A.
Pad thickness
NOTE:
• Always replace the pads of both sides as a set.
• Replace pad clips if they are twisted or worn.
BR-00606 • A wear indicator is installed on the inner disc
brake pad. If the pad is worn to the limit, the end of
wear indicator contacts disc rotor, and a squeaking
sound is heard as the wheel rotates. If the sound is
heard, replace the pad.
• Replace the pad if there is oil or grease on it.
3. 17-INCH TYPE
Check the pad thickness A.
BR-00016
9.0 mm (0.354 in)
Pad thickness
1.5 mm (0.059 in)
NOTE:
• Always replace the pads of both sides as a set.
• Replace pad clips if they are twisted or worn.
• A wear indicator is installed on the inner disc
brake pad. If the pad is worn to the limit, the end of
wear indicator contacts disc rotor, and a squeaking
sound is heard as the wheel rotates. If the sound is
heard, replace the pad.
• Replace the pad if there is oil or grease on it.
BR-31
BRAKE
A
BR-00314
Standard 11.5 mm (0.452 in)
Wear limit 1.5 mm (0.059 in)
A
BR-00314
Standard 9.0 mm (0.354 in)
Wear limit 1.2 mm (0.047 in)