Subaru IMPREZA GD 2007 Series Manual page 2989

asieps_tobira_IM_US.book 84 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Install the 1st-2nd hub.
NOTE:
• Match the cut out of the 1st-2nd hub with the pro-
trusion on the outer baulk ring, then install.
• Make sure that the 1st-2nd hub is installed in the
correct direction.
(C)
(D)
(E)
(A) 1st-2nd hub
(B) Outer baulk ring
(C) 1st-2nd hub cut out section
(D) Protrusion of the outer baulk ring
(E) 1st driven gear
8) Using the ST, install the 2nd hub.
ST 18654AA000 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 Imp ton).
(A) 2nd bushing
(B) 1st-2nd hub
Driven Gear Assembly
9) Make sure that the 1st drive gear can be turned
smoothly by hand. If it does not turn smoothly, re-
assemble.
10) Attach the shifting insert key to the appropriate
position of the 1st-2nd sleeve.
NOTE:
The angle of each shifting insert key is 120°.
(A)
(B)
(E)
(A)
MT-00600
ST
(A)
(B)
MT-00601
6MT-84
MT-00602