Subaru IMPREZA GD 2007 Series Manual page 3433

asieps_tobira_IM_US.book 27 ページ ２０１２年１月１７日 火曜日 午後３時４８分
12) Carefully draw out the input shaft and remove
the valve assembly.
13) Using a sharp pointed pliers, rotate the rack
stopper in direction of the arrow until end of the cir-
clip comes out of stopper. Rotate the circlip in op-
posite direction and pull it out.
(1)
(1) Rack stopper
14) Pull the rack assembly from cylinder side, and
draw out the rack bushing and rack stopper togeth-
er with the rack assembly.
CAUTION:
Be careful not to contact the rack to inner wall
of cylinder when drawing out. Any scratch on
the cylinder inner wall will cause oil leakage.
(2)
(3)
(1) Rack bushing
(2) Rack ASSY
(3) Rack stopper
15) Remove the rack bushing and rack stopper
from rack assembly.
16) Remove the oil seal from rack.
Steering Gearbox
PS-00117
PS-00121
(1)
PS-00271
PS-27
POWER ASSISTED SYSTEM (POWER STEERING)
17) Insert the ST from pinion housing side and re-
move the oil seal using a press.
ST 34199AE050 OIL SEAL REMOVER
(1)
(1) Press
(2) Oil seal
Control valve assembly
1) Disconnect the four pipes from gearbox.
NOTE:
Remove the pipes E and F fixed at clamp plate as
a single unit.
2) Secure the gearbox removed from vehicle in a
vise using ST.
ST 926200000 STAND
CAUTION:
Secure the gearbox in a vise using ST as shown
in the figure. Do not secure the gearbox without
this ST.
ST
(2)
PS-00138
ST
PS-00029