Subaru IMPREZA GD 2007 Series Manual page 2800

asieps_tobira_IM_US.book 27 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4. Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Set the select lever to "N" range.
3) Disconnect the ground cable from the battery.
4) Lift up the vehicle.
5) Remove the front, center and rear exhaust pipes
and the muffler. (SOHC model)
<Ref. to EX(H4SO)-4, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-7, REMOVAL, Center
Exhaust Pipe.> <Ref. to EX(H4SO)-8, REMOVAL,
Rear Exhaust Pipe.> <Ref. to EX(H4SO)-9, RE-
MOVAL, Muffler.>
6) Remove the center and rear exhaust pipes and
the muffler. (DOHC Turbo model)
<Ref. to EX(H4DOTC)-10, REMOVAL, Center Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-15, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4DOTC)-
17, REMOVAL, Muffler.>
7) Remove the snap pin and washer from range se-
lect lever.
(D)
(C) (E)
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
8) Remove the plate assembly from the transmis-
sion case.
( A )
( C )
(A) Select cable
(B) Plate ASSY
(C) Clamp
Select Cable
(A)
(B)
CS-00036
( B )
CS-00037
CS-27
9) Disconnect the cable from select lever and then
remove the cable bracket.
(B)
(A) Adjusting nut
(B) Cable bracket
10) Remove the select cable from plate assembly.
B: INSTALLATION
1) Install the select cable to plate assembly.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
2) Install the select cable to range select lever.
3) Install the plate assembly to transmission.
Tightening torque:
T: 24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
(A)
T
(B)
(A) Select cable
(B) Plate ASSY
CONTROL SYSTEMS
(A)
CS-00038
CS-00039