Subaru IMPREZA GD 2007 Series Manual page 2593

asieps_tobira_IM_US.book 86 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
4) Remove the thrust washers, pinion gears and
washers from center differential assembly.
(A) Pinion gear
5) Pull out the intermediate shaft and thrust bear-
ing.
D: ASSEMBLY
1) Install the thrust bearing onto intermediate shaft.
2) Insert the intermediate shaft into the carrier.
3) Attach the pinion gear, needle bearing and
washer onto the carrier.
4) Insert the shaft into the center differential as-
sembly.
5) Install the snap ring.
6) Using a press, install a new ball bearing into the
center differential assembly.
ST 498077000 REMOVER
(B)
(A) Plate
(B) Center differential carrier
7) Apply ATF onto the seal ring outer surface and
shaft grooves.
8) Apply ATF to new seal rings, then install.
E: INSPECTION
• Check each part to make sure that there are no
holes, cuts, or attached dust.
• Inspect the extension aid play, and adjust it to be
within the standard value. <Ref. to 4AT-78, VTD
MODEL, ADJUSTMENT, Transfer Clutch.>
Center Differential Carrier
(A)
AT-00169
(A)
ST
AT-00170
4AT-86