Subaru IMPREZA GD 2007 Series Manual page 3359

asieps_tobira_IM_US.book 35 ページ ２０１２年１月１７日 火曜日 午後３時４８分
8) Tighten the boot bands using ST, torque wrench
and socket flex handle.
ST 28099AC000 BOOT BAND PLIER
(C)
(B)
(A)
(A) Large boot band
(B) Boot
(C) Torque wrench
(D) Socket flex handle
(E) BJ
Tightening torque:
Large boot band
157 N·m (16.0 kgf-m, 116 ft-lb) or more
Small boot band
133 N·m (13.6 kgf-m, 98 ft-lb) or more
9) Place the PTJ boot at the center of shaft.
10) Align alignment marks and install the trunnion
on the shaft.
11) Install the snap ring to shaft.
CAUTION:
Confirm that the snap ring is completely fitted
in shaft groove.
12) Fill 100 to 110 g (3.53 to 3.88 oz) of specified
grease into the interior of PTJ outer race.
13) Apply a thin coat of specified grease to the roll-
er kit and trunnion.
Front Drive Shaft
14) Align alignment marks on roller kit and trunnion
and install the roller kit.
CAUTION:
Be careful with the roller kit position.
(D)
ST
(E)
DS-00116
15) Align the alignment marks of the shaft and out-
er race, and install the outer race.
DS-00110
16) Install the snap ring in the groove on PTJ outer
race.
CAUTION:
Pull the shaft lightly and assure that the snap
ring is completely fitted in the groove.
17) Apply an even coat of the specified grease 30
to 40 g (1.06 to 1.41 oz) to the entire inner surface
of boot.
18) Install the PTJ boot taking care not to twist it.
CAUTION:
• The PTJ installing surface of PTJ boot shall
be cleaned completely so as to be free from
grease and other substances.
• When installing PTJ boot, position outer race
of PTJ at center of its travel.
DS-35
DRIVE SHAFT SYSTEM
DS-00208
DS-00106