Subaru IMPREZA GD 2007 Series Manual page 2940

asieps_tobira_IM_US.book 35 ページ ２０１２年１月１７日 火曜日 午後３時４８分
16) Remove the center and rear exhaust pipes and
the muffler. <Ref. to EX(H4DOTC)-10, REMOVAL,
Center Exhaust Pipe.>, <Ref. to EX(H4DOTC)-15,
REMOVAL, Rear Exhaust Pipe.>, <Ref. to
EX(H4DOTC)-17, REMOVAL, Muffler.>
CAUTION:
When removing the exhaust pipes, be careful
each exhaust pipe does not drop out.
17) Drain the transmission gear oil. <Ref. to 6MT-
28, Transmission Gear Oil.>
18) Remove the propeller shaft. <Ref. to DS-15,
REMOVAL, Propeller Shaft.>
19) Remove the front stabilizer bolt.
20) Remove the ball joint of the transverse link from
the housing.
21) Remove the front drive shaft. <Ref. to DS-31,
REMOVAL, Front Drive Shaft.>
22) Hang the front drive shaft with string.
23) Set the transmission jack under the transmis-
sion, and remove the front crossmember and rear
crossmember.
Manual Transmission Assembly
24) Move the transmission to the right side of the
vehicle, and remove the joint COMPL, stay bolts
and reverse check cable.
NOTE:
If the transmission is not moved aside, the joint
COMPL and stay bolts may contact the body and
cause damage.
25) Tighten the turnbuckle of the ST to tilt the en-
MT-00076
gine assembly towards the back.
26) Remove the bolts holding the engine and trans-
MT-00460
mission together, and remove the transmission
from the vehicle.
NOTE:
• When pulling towards the rear during removal,
be careful not to hit the transmission against the
body.
• The clutch pipe and breather pipe may interfere
with each other. Remove carefully.
MT-00454
6MT-35
MANUAL TRANSMISSION AND DIFFERENTIAL
(C)
(A)
(B)
(A) Joint COMPL bolt
(B) Stay bolt
(C) Reverse check cable
MT-00886
MT-00463
MT-01470