Subaru IMPREZA GD 2007 Series Manual page 3120

asieps_tobira_IM_US.book 13 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4. Front ABS Wheel Speed Sensor
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Disconnect the ABS wheel speed sensor con-
nector located next to the front strut mounting
house in the engine compartment. Pull out the con-
nector to the tire side from grommet hole.
3) Remove the bolts which secure the sensor har-
ness to the strut.
4) Remove the bolts which secure the sensor har-
ness to the body.
(1) To the front ABS wheel speed sensor connector
(2) Bracket
5) Remove the bolts which secure front ABS wheel
speed sensor to the housing, and remove the front
ABS wheel speed sensor.
CAUTION:
• Be careful not to damage the pole piece and
the face of the teeth located at the end of the
sensor during removal.
• Do not pull sensor harness during removal.
Front ABS Wheel Speed Sensor
ABS00140
(1)
(2)
ABS00849
ABS00142
ABS-13
B: INSTALLATION
1) Temporarily attach the front ABS wheel speed
sensor on the housing.
CAUTION:
Be careful not to hit the ABS wheel speed sen-
sor pole piece and tone wheel against adjacent
metal parts during installation.
2) Install the front ABS wheel speed sensor on the
strut and the wheel apron.
Tightening torque:
33 N·m (3.3 kgf-m, 24 ft-lb)
(1) To the front ABS wheel speed sensor connector
(2) Bracket
ABS
ABS00142
(1)
(2)
ABS00849