Subaru IMPREZA GD 2007 Series Manual page 2556

asieps_tobira_IM_US.book 49 ページ ２０１２年１月１７日 火曜日 午後３時４８分
D: INSTALLATION
1) Connect the inhibitor switch harness connector
to the inhibitor switch.
2) Install the inhibitor switch to the transmission
case.
(A)
(A) Inhibitor switch
3) Move the range select lever to the neutral posi-
tion.
4) Using the ST, tighten the bolts of the inhibitor
switch.
ST 499267300 STOPPER PIN
Tightening torque:
3.5 N·m (0.36 kgf-m, 2.6 ft-lb)
ST
(A) Inhibitor switch
(B) Range select lever
5) Install the select cable to the range select lever.
Inhibitor Switch
AT-00038
(A)
(B)
AT-00039
4AT-49
AUTOMATIC TRANSMISSION
6) Install the plate assembly to the transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
( A )
T
( B )
(A) Select cable
(B) Plate ASSY
7) Install the washer and snap pin to the range se-
lect lever.
(A)
(C) (D)
(A) Range select lever
(B) Snap ring
(C) Select cable
(D) Washer
8) Install the front and center exhaust pipe. (Non-
turbo model) <Ref. to EX(H4SO)-5, INSTALLA-
TION, Front Exhaust Pipe.>
9) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-11, INSTALLATION, Center
Exhaust Pipe.>
10) Lower the vehicle.
11) Install the inhibitor switch connector to the stay.
AT-00040
(B)
AT-00034