Subaru IMPREZA GD 2007 Series Manual page 2599

asieps_tobira_IM_US.book 92 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
2. OIL SEAL RETAINER
1) Remove the oil seal retainer.
(A) Oil seal retainer
(B) Drive pinion shaft
2) Remove the O-ring.
(A)
(A) O-ring
3) Remove the oil seal from the oil seal retainer.
(A)
(A) Oil seal
(B) Oil seal retainer
Oil Pump Housing
(B)
(A)
AT-03598
AT-03361
(A)
(B)
AT-04088
4AT-92
D: ASSEMBLY
1. OIL PUMP COVER
1) Install the oil pump rotor assembly to oil pump
housing.
(A)
(A) Inner rotor
(B) Outer rotor
2) Align both pivots with the pivot holes of the cov-
er, and then install the oil pump cover while being
careful not to apply excessive force to the pivots.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
(A)
(A) Oil pump cover
(B) Oil pump housing
3) After assembling, turn the oil pump shaft to
check for smooth rotation of rotor.
4) Install the oil seal retainer and new seal rings.
After installing, adjust the tooth contact with the
drive pinion backlash. <Ref. to 4AT-94, ADJUST-
MENT, Oil Pump Housing.>
(B)
AT-01036
(B)
AT-00190