Subaru IMPREZA GD 2007 Series Manual page 2611

asieps_tobira_IM_US.book 104 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
3) Pull out the straight pin and shaft, and then re-
move the differential bevel gear, washer and differ-
ential bevel pinion.
(A) Differential case (RH)
2. SIDE RETAINER
NOTE:
After adjusting the drive pinion backlash and tooth
contact, remove and install the oil seal and O-ring.
1) Remove the O-ring.
2) Remove the oil seal.
Front Differential Assembly
3) Remove the split pin, and then remove the claw.
ST 398527700
(A)
AT-00218
4) Attach two claws to the outer race, and set the
ST to side retainer.
ST 398527700
AT-00219
5) Restore the removed claws to original position,
and install the pin and split pin.
6) Hold the shaft of ST to avoid removing from side
retainer, and then remove the bearing outer race.
ST 398527700
NOTE:
Replace the bearing inner and outer races as a sin-
gle unit.
AT-00220
4AT-104
PULLER ASSY
(A) Claw
(B) Split pin
(C) Pin
PULLER ASSY
(A) Shaft
(B) Claw
PULLER ASSY
(A) Shaft
(B) Side retainer
AT-00221
AT-00222
AT-00223