Subaru IMPREZA GD 2007 Series Manual page 2756

asieps_tobira_IM_US.book 23 ページ ２０１２年１月１７日 火曜日 午後３時４８分
C: DISASSEMBLY
NOTE:
Since the operating cylinder for 6MT model cannot
be disassembled, disassembly is available only for
5MT model.
1) Remove the boot and push rod.
NOTE:
The illustration below is for a non-turbo model.
2) Blow compressed air through the clutch hose at-
tachment hole.
NOTE:
• Face the piston port down and place a piece of
wood underneath to prevent the piston from pop-
ping out.
• The illustration below is for a non-turbo model.
3) Separate the piston and piston spring.
NOTE:
The illustration below is for a non-turbo model.
Operating Cylinder
D: ASSEMBLY
NOTE:
• During assembly, apply hydraulic oil to all parts.
• Since the operating cylinder for 6MT model can-
not be disassembled, assembly is available only for
5MT model.
Recommended clutch fluid:
New FMVSS No. 116 DOT3 or DOT4 brake fluid
1) Install the piston spring to the piston.
NOTE:
The illustration below is for a non-turbo model.
CL-00457
2) Insert the piston into the operating cylinder.
3) Attach the push rod to the boot.
4) Attach the boot and push rod to the operating
cylinder.
NOTE:
The illustration below is for a non-turbo model.
CL-00458
E: INSPECTION
1) Check the operating cylinder for damage. If op-
erating cylinder is damaged, replace it.
2) Check the operating cylinder for fluid leakage or
damage on the boot. If any leakage or damage is
found, replace the operating cylinder.
CL-00459
CL-23
CLUTCH SYSTEM
CL-00459
CL-00457