Subaru IMPREZA GD 2007 Series Manual page 2941

asieps_tobira_IM_US.book 36 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
27) Remove the transmission cushion rubber from
transmission.
B: INSTALLATION
1) Set the release fork, release bearing and release
shaft to the transmission. <Ref. to CL-18, INSTAL-
LATION, Release Bearing and Lever.>
2) Install the transmission cushion rubber to the
transmission.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
3) Replace the front differential side retainer oil
seal.
(1) Remove the oil seal by using flat tip screw-
driver etc.
(2) Apply gear oil to the lip of new oil seals.
(3) Install a new oil seal using ST.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
Be sure to replace the differential side oil seal after
the procedure of removing front drive shaft from
transmission.
Manual Transmission Assembly
4) Loosen the turnbuckle of ST to return the engine
to its original position.
MT-01273
5) Install the transmission.
6) Tighten the bolts and nuts which hold the lower
side of transmission to the engine.
NOTE:
• Make sure that the main shaft spline is complete-
ly inserted.
• Make sure that the rear end of the engine is set
low.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
MT-01273
7) Move the transmission to the right side of the ve-
hicle, and attach the joint COMPL, stay bolts and
reverse check cable.
Tightening torque:
T1: 11.8 N·m (1.2 kgf-m, 8.7 ft-lb)
T2: 32 N·m (3.3 kgf-m, 23.6 ft-lb)
6MT-36
(A)
T1
T2
(A) Reverse check cable
MT-01527
MT-00464
MT-00465