Subaru IMPREZA GD 2007 Series Manual page 3144

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to the Subaru Se-
lect Monitor.
3) Connect the Subaru Select Monitor to the data
link connector.
(1) The data link connector is located in the low-
er portion of the instrument panel (on the driv-
er's side).
(2) Connect the diagnosis cable to the data link
connector.
CAUTION:
Do not connect any scan tools except Subaru
Select Monitor and general scan tool.
4) Turn the ignition switch to ON (engine OFF) and
run the Subaru Select Monitor.
5) Select {Each System Check} in the «Main
Menu» screen.
6) Select {Brake Control} in the «Selection Menu»
screen.
7) Select [YES] after the information of engine type
is displayed.
8) On the «ABS Diagnosis» screen, select {DTC
Display}.
9) On the «Diagnostic Code(s) Display» screen,
select {Current Diagnostic Code(s)} or {History Di-
agnostic Code(s)}.
NOTE:
• For details concerning the operation procedure,
refer to the «SUBARU SELECT MONITOR OPER-
ATION MANUAL».
• For details concerning DTCs, refer to List of Di-
agnostic Trouble Code (DTC). <Ref. to ABS(diag)-
34, List of Diagnostic Trouble Code (DTC).>
• Up to 3 DTCs are displayed in the order of detec-
tion.
Subaru Select Monitor
• If a particular DTC is not stored in memory prop-
erly at the occurrence of problem (due to a drop in
ABSCM&H/U power supply etc.), the DTC suffixed
with a question mark "?" is displayed on Subaru Se-
lect Monitor display screen. This shows it may be
an unreliable reading.
Display
Current
Old
Older
Third previous
EN-01163
ABS(diag)-15
ABS (DIAGNOSTICS)
Contents to be monitored
The current DTC is displayed on Subaru
Select Monitor display screen.
The latest DTC from the history of previ-
ous problems is displayed on Subaru
Select Monitor display screen.
The second latest DTC from the history
of previous problems is displayed on the
Subaru Select Monitor display screen.
The third latest DTC from the history of
previous problems is displayed on Sub-
aru Select Monitor display screen.