Subaru IMPREZA GD 2007 Series Manual page 3431

asieps_tobira_IM_US.book 25 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6) After tightening the castle nut to the specified
tightening torque, tighten it further within 60° until
the cotter pin hole is aligned with slot in the nut. Fit
the cotter pin into the nut, and then bend the pin to
lock.
(A)
(B)
(C)
(A) Cotter pin
(B) Castle nut
(C) Tie-rod end
7) Install the front stabilizer to vehicle. <Ref. to FS-
21, INSTALLATION, Front Stabilizer.>
8) Install the front exhaust pipe assembly. (Non-tur-
bo model) <Ref. to EX(H4SO)-5, INSTALLATION,
Front Exhaust Pipe.>
9) Install the sub frame. <Ref. to FS-23, INSTAL-
LATION, Sub Frame.>
10) Install the under cover. <Ref. to EI-23, INSTAL-
LATION, Front Under Cover.>
11) Align the center position of the roll connector.
<Ref. to AB-19, ADJUSTMENT, Roll Connector.>
12) Install the steering wheel. <Ref. to PS-18, IN-
STALLATION, Steering Wheel.>
13) Install the front wheels.
14) Tighten the wheel nuts to the specified torque.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
15) Connect the ground cable to the battery.
16) Pour fluid into the oil tank, and bleed air.
<Ref. to PS-66, Power Steering Fluid.>
17) Check for fluid leaks.
18) Install the jack-up plate.
19) Lower the vehicle.
20) Check the fluid level in oil tank.
Steering Gearbox
POWER ASSISTED SYSTEM (POWER STEERING)
21) After adjusting toe-in and steering angle, tight-
en the lock nut on tie-rod end.
Tightening torque:
83 N·m (8.5 kgf-m, 61.5 ft-lb)
NOTE:
When adjusting toe-in, hold the boot as shown to
prevent it from being rotated or twisted. If it be-
comes twisted, straighten it.
DS-00042
C: DISASSEMBLY
1. NON-TURBO MODEL
RACK HOUSING ASSEMBLY
1) Disconnect the four pipes from gearbox.
NOTE:
Remove the pipes E and F, which are fixed to the
clamp plate, as a unit.
2) Secure the gearbox removed from vehicle in a
vise using ST.
ST 926200000
CAUTION:
Secure the gearbox in a vise using ST as shown
in the figure. Do not secure the gearbox without
this ST.
3) Remove the tie-rod end and lock nut from gear-
box.
PS-25
PS-00051
STAND
ST
PS-00029