Subaru IMPREZA GD 2007 Series Manual page 2874

asieps_tobira_IM_US.book 51 ページ ２０１２年１月１７日 火曜日 午後３時４８分
15.Transmission Case
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 5MT-25, REMOVAL,
Manual Transmission Assembly.>
2) Remove the clutch release lever. <Ref. to CL-
18, REMOVAL, Release Bearing and Lever.>
3) Remove the transfer case together with the ex-
tension case assembly. <Ref. to 5MT-39, REMOV-
AL, Transfer Case
Assembly.>
4) Remove the bearing mounting bolt.
5) Remove the main shaft rear plate.
(A)
(A) Main shaft rear plate
6) Separate the transmission case into the right
and left cases by loosening the coupling bolts and
nuts.
Transmission Case
and Extension Case
MT-01514
MT-01515
MT-00160
5MT-51
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Remove the drive pinion shaft assembly from
the left side of the transmission case.
NOTE:
Use a hammer handle, etc. to remove if too tight.
( B )
(A) Main shaft ASSY
(B) Drive pinion shaft ASSY
8) Remove the main shaft assembly.
9) Remove the front differential assembly.
NOTE:
• Do not confuse the right and left roller bearing
outer races.
• Be careful not to damage the oil seal of retainer.
B: INSTALLATION
1) Wipe off grease, oil and dust on the mating sur-
faces of transmission cases with cleaning solvent.
2) Install the front differential assembly.
3) Install the main shaft assembly.
Install the transmission case knock pin into the
knock pin hole of needle bearing.
4) Install the drive pinion shaft assembly.
Install the transmission case knock pin into the roll-
er bearing knock pin hole.
5) Apply liquid gasket, and then join the right side
and left side of the case together.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
( A )
MT-00161
MT-00162