Subaru IMPREZA GD 2007 Series Manual page 2544

asieps_tobira_IM_US.book 37 ページ ２０１２年１月１７日 火曜日 午後３時４８分
9. Automatic Transmission
Assembly
A: REMOVAL
1) Set the vehicle on a lift.
2) Open the front hood and support with the hood
stay.
3) Disconnect the ground cable from the battery.
4) Remove the air intake chamber and intake duct.
(Non-turbo model) <Ref. to IN(H4SO)-6, REMOV-
AL, Air Intake Chamber.>
5) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-13, REMOVAL, Intercooler.>
6) Remove the air intake chamber stay. (Non-turbo
model)
7) Disconnect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground terminal
8) Remove the starter. <Ref. to SC(H4SO)-8, RE-
MOVAL, Starter.>
9) Remove the throttle body. <Ref. to FU(H4SO)-
12, REMOVAL, Throttle
FU(H4DOTC)-16, REMOVAL, Throttle Body.>
Automatic Transmission Assembly
10) Remove the pitching stopper.
11) Separate the torque converter clutch from the
drive plate.
CAUTION:
• Be careful not to damage the mounting bolts.
• Be careful not to drop bolts into the converter
case.
AT-00101
12) Attach the ST to the converter case.
ST 498277200
AT-00678
Body.> <Ref. to
4AT-37
AUTOMATIC TRANSMISSION
(1) Install the V-belt cover.
(2) Remove the service hole plug.
(3) Remove the bolts which hold the torque
converter clutch to the drive plate.
(4) While rotating the crank pulley in the direc-
tion of engine rotation a little bit at a time, re-
move all bolts.
STOPPER SET
ST
AT-00679
AT-00102
AT-00804