Subaru IMPREZA GD 2007 Series Manual page 2629

asieps_tobira_IM_US.book 122 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
(3) Scale and record the weight Z of a flat board
which will be put on retaining plate.
NOTE:
• Use a stiff board which does not bend against
load as a flat board to be put on retaining plate.
• Use a flat board weighing less than 25.5 kg (56.2
lb).
(4) Put the flat board on retaining plate.
(5) Using the following formula, read the push/
pull gauge, and calculate N.
N = 250 N (25.5 kgf, 56.2 lbf) – Z
N: Value indicated on push/pull gauge
250 N (25.5 kgf, 56.2 lbf): Load applied to clutch
plate
Z: Flat board weight
(6) Press the center of retaining plate by apply-
ing a force of N using push/pull gauge, and then
measure and record the height "A". Measure at
three locations or more spaced by equal dis-
tances and take the average value.
AT Main Case
NOTE:
If measuring in three locations, measure every
120°. If measuring in four locations, measure every
90°.
A
AT-01720
(A) Driven plate
(B) Drive plate
(C) Retaining plate
4AT-122
(C)
(B)
(A)
AT-01725