Subaru IMPREZA GD 2007 Series Manual page 2872

asieps_tobira_IM_US.book 49 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2) Remove the reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
(A)
(C)
(B)
(D)
(F)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove the O-ring.
NOTE:
• Visually check the O-ring. Replace if faulty.
• Be careful not to damage the adjusting shim be-
tween reverse check sleeve assembly and the case.
D: ASSEMBLY
1) Install the return spring (1st-2nd), return spring
cap, reverse accent shaft, reverse check cam, re-
turn spring (5th-Rev) and check spring to the re-
verse check sleeve.
NOTE:
Be sure to position the bent section of reverse
check spring to fit in the groove of the check cam.
(A)
(C)
(B)
(D)
(F)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
Reverse Check Sleeve
2) Hook the curved section of the reverse check
spring over the reverse check plate.
3) Rotate the cam so that the protrusion of the re-
verse check cam comes to the opening of the plate.
4) With cam held in that position, install the reverse
check plate onto the reverse check sleeve and hold
in place with the snap ring.
5) Position the new O-ring in the groove of sleeve.
(E)
E: INSPECTION
(G)
• Make sure the cutout of the reverse accent shaft
is aligned with the opening in the reverse check
sleeve.
• Turn the cam by hand to check for smooth rota-
MT-00154
tion.
• Move the cam and shaft all the way toward the
plate, and make sure it releases.
If the cam does not return properly, replace the re-
verse check spring. If the shaft does not return,
check for scratches on the inner surface of sleeve.
If the sleeve is in good order, replace the spring.
• Select a suitable reverse accent shaft and re-
verse check plate. <Ref. to 5MT-50, ADJUST-
MENT, Reverse Check Sleeve.>
(E)
(G)
MT-00154
5MT-49
MANUAL TRANSMISSION AND DIFFERENTIAL
(D)
(B)
(A) Snap ring
(B) Reverse check plate
(C) Checking spring
(D) Check cam
(C)
(A)
MT-00156