Subaru IMPREZA GD 2007 Series Manual page 2996

asieps_tobira_IM_US.book 91 ページ ２０１２年１月１７日 火曜日 午後３時４８分
D: ASSEMBLY
1) Attach the sub gear and spring.
NOTE:
• Turn the white marking on the hook section to-
wards the sub gear side, and attach the spring.
• Point the stamp (marking A) towards the outside,
and install the sub gear.
(B)
(A)
(C)
(A) Sub gear
(B) Spring
(C) Stamp (Marking A)
• While paying attention to the direction of the sub
gear attachment hole, attach the spring and sub gear.
(A)
(A) Attachment hole
2) Install the friction plate and snap ring.
NOTE:
Confirm that the friction plate is installed in the
proper direction.
(A) Friction plate
(B) Snap ring
(C) Snap ring side
(D) Sub gear side
Reverse Idler Gear Assembly
3) Apply adequate gear oil to the shaft, needle
bearing and reverse drive gear inner surface.
4) Install the knock pin.
5) Install the washer and the needle bearing.
NOTE:
Point the groove towards the reverse idler gear,
MT-00628 and attach the washer.
6) Install the reverse idler gear No. 2.
MT-00629
(C)
(D)
(B)
(A)
MT-00630
6MT-91
MANUAL TRANSMISSION AND DIFFERENTIAL
(C)
(B)
(A) Groove
(B) Washer
(C) Needle bearing
MT-00626
(A)
MT-00631
MT-00632