Subaru IMPREZA GD 2007 Series Manual page 3006

asieps_tobira_IM_US.book 101 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4) Install the differential side retainers to both
sides, using the ST.
ST1 499787000 WRENCH ASSY (RH SIDE)
ST2 18630AA000 WRENCH ASSY (LH SIDE)
NOTE:
Be careful not to damage the oil seal.
(B)
(A)
(A) LH side
(B) RH side
5) Inspect and adjust the hypoid gear backlash.
<Ref. to 6MT-104, HYPOID GEAR BACKLASH,
INSPECTION, Front Differential Assembly.>
6) Inspect and adjust the tooth contact. <Ref. to
6MT-97, ADJUSTMENT, Drive Pinion Shaft As-
sembly.>
7) Mark the mating positions of the left and right
side retainers and the clutch housing.
8) Remove the differential side retainers from both
sides.
NOTE:
When removing the differential side retainer, record
how many times it was turned to remove.
Front Differential Assembly
9) Install O-rings to the differential side retainers on
both sides.
10) Attach the differential side retainers to both
sides.
NOTE:
When attaching, turn the differential side retainer
the same number of turns it took to remove, and
ST1
align the marks.
11) Install the retainer lock plate.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
NOTE:
Be careful not to confuse the left and right side re-
tainer lock plates.
ST2
MT-00657
12) Remove any remaining liquid gasket from the
clutch housing and adapter plate.
13) Apply liquid gasket to the clutch housing.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
14) Install the drive pinion shaft assembly. <Ref. to
6MT-94, INSTALLATION, Drive Pinion Shaft As-
sembly.>
15) Install the individual gear assemblies all at
MT-00658
once. <Ref. to 6MT-69, INSTALLATION, Main
Shaft Assembly.>
16) Install the transmission case. <Ref. to 6MT-64,
INSTALLATION, Transmission Case.>
17) Install the oil pump. <Ref. to 6MT-61, INSTAL-
LATION, Oil Pump.>
6MT-101
MANUAL TRANSMISSION AND DIFFERENTIAL
(A) (B)
(A) LH
(B) RH
MT-00659
MT-00532